ENGLISH
30
Assembly and filling
When you have chosen a suitable location, assemble the pool and fill it with water as instructed below.
IMPORTANT!
Two adults are required to assemble the pool. The pool is ready for use within half an
hour.
We recommend leaving the unrolled pool exposed to sunlight for an hour or more. This makes the
material more supple and easy to handle.
If the pool comes with a ground sheet, spread the sheet out over the chosen site. The ground sheet
must be smooth and flat without any visible folds or bumps.
1.
Place the pool with its hose connections in the direction of where the filter pump is going to be
sited. It is important to place the pool correctly in relation to the power outlet to which the filter
pump is going to be connected. Check that the pump power cord reaches the power outlet without
any problem. Also check that the drain valve is suitably positioned to enable easy draining at the
end of the season. IMPORTANT! Do not pull or drag the pool across the ground. This can damage
the pool or cause other damage.
2.
Carefully unfold the pool and stretch the wall and bottom to make them as smooth as possible.
NOTE: You will find it easiest to assemble the pool on a hot, sunny day. We recommend leaving
the unrolled pool exposed to sunlight for an hour or more. This makes the material more supple
and easy to handle.
3.
Locate the horizontal brace (A) (the longer brace with
a larger diameter, with a pin in each end). Insert the
first brace into the channel in the upper edge of the
pool liner. The brace should be protruding equally at
both ends. Push the end of the brace in the larger
hole onto a T piece (C) and push a plastic pin through
the holes in the T piece (C) and the brace (A).
4.
Repeat all the way round the pool until all the braces are in place.
NOTE:
It can be difficult to put the last joint together. To make it easier, raise the parts about 10 cm, fit
them together and then lower them.
5.
After you have fitted the upper braces, assemble the
vertical supports (B). Insert a support through the
strap and into a T piece. Align the two pins with the
holes and press until the support clicks into position.
Make sure that the support is inside the cord that runs
around the base of the pool. Assemble all the legs all
the way around the pool.
Hose
connections
Inlet
Outlet
