ENGLISH
19
Cleaning floors
Fit the extension nozzle, if required, to the nozzle holder. Fit the angled nozzle or the round brush nozzle
on the extension nozzle. Point the nozzle at the floor and press the steam control to remove dirt and
stains from floors and corners.
Use
1.
Unpack the appliance, check that all accessories and documents are included. Check the
appliance and accessories for damage.
2.
Read these instructions carefully before use. The appliance is designed for household use only.
3.
Place the appliance on a flat surface, push down the safety cap and turn it anti-clockwise. Fit the
funnel.
4.
Fill the measuring jug with 175 ml of clean water and pour the water in the reservoir. The reservoir
holds 250 ml. Do not pour in too much water as there must be some space left in the reservoir.
Refit the safety cap and tighten it firmly.
5.
Check that the data in the operating instructions for the appliance corresponds to the mains supply
voltage at the point of use. Insert the power cord and turn on the appliance.
6.
The appliance is ready for use after four minutes. Gently press the steam control and check that
steam is coming from the nozzle. Do not point the nozzle at people or objects.
7.
If steam comes from the nozzle release the steam control and fit the accessories required.
8.
Press the steam control and you can start working.
Fitting the accessories
1.
Fitting the brush nozzle.
Hold the brush nozzle with the arrow on the nozzle towards the mark on the nozzle holder. Press the
nozzle in place. Turn the nozzle clockwise so the arrow on the nozzle is aligned with the double lines on
the nozzle holder. Attach the nozzle to the appliance. Remove the nozzle by turning it anti-clockwise (see
fig. 2) so that the arrow on the nozzle is in line with the mark on the casing. Pull off the nozzle.
