ENGLISH
8
ENGLI SH
SAFETY INSTRUCTIONS
Read these instructions carefully before use!
Be careful when screwing the bulb into the lamp base. The bulb will break if handled carelessly.
If you are not sure about the installation or encounter problems, call an authorised electrician.
Check that the power supply is disconnected before you start the installation.
NOTE:
Do not use the fitting if the power cord and/or plug are damaged in any way. For safety
reasons, the power cord must only be replaced or repaired by an authorised service centre.
Consult your dealer.
INSTALLATION
1.
Remove the backpiece from the fitting.
2.
Use the backpiece as a template in order to mark the drill holes on the wall where the fitting is to be
mounted. Drill the holes and insert the wall plugs supplied.
3.
Take the lamp glass sections out of the protective packaging.
4.
Put the glass sections in position (figure 1). Be very careful not to pull the glass sections too hard
as they will break.
5.
Remove the casing beneath the lamp to access the terminal block (figure 2). Push the power cord
from the mains power supply through the watertight bushing underneath the backpiece.
6.
Screw the bulb in the lamp base.
7.
Fit the lamp housing on the backpiece using the screw supplied. Take care to align the lamp
housing correctly before tightening the screw.
Figure 1
Figure 2
Routing The Wires
Colour of fitting's mains wire
Colour of household's mains wire
Blue wire, connects to:
Blue or black wire (neutral)
Green/yellow wire, connects to:
Green/yellow wire (earth)
Brown wire, connects to:
Red or brown wire (live)