−
48
−
3) Stitch base line (left side : 52)
1. Select 52 with [Left
or
] key
2
.
2. Press
key
4
.
3. Turn the hand pulley to bring the needle to the
lowest point of its stroke on the stitch base line side.
4. Press [Right] key
3
to set the needle to the center
of the needle hole in the throat plate. (When the
needle does not move, press [Right] key after
pressing
key
4
.)
5. Loosen the screw in the stitch base line origin
detecting plate and fix the plate at the position of
ON where the lamp in the center of the lower left of
the panel turns almost ON or OFF. (Refer to page
6.)
6. Press the right side key to set the right side to “0”.
7. Press
key
4
and make sure that the needle is
in the center of the needle hole in the throat plate.
4) Stitch width (Left side : 53)
1. Select 53 with [Left
or
] key
2
.
2. Press
key
4
.
3. Turn the hand pulley to bring the needle to the
lowest point of its stroke on the stitch width side.
4. Press the right side key to set the needle in the
center of the needle hole in the throat plate. (When
the needle does not move, press the right side key
after pressing
key
4
.)
5. Loosen the screw in the stitch width origin detecting
plate and fix the plate at the position of ON where
the lamp on the right side of the lower left of the
panel turns almost ON or OFF. (Refer to page 8.)
6. Press the right side key to set the right side to “0”.
7. Press
key
4
and turn the hand pulley to make
sure that the needle does not rock.
8. Turn OFF the power.
Needle entry
point
Adjust when the needle
bar rocking cam is on the
stitch base line side.
Adjust when the needle
bar rocking cam is on
the stitch width side.
N e e d l e e n t r y
point
