JUKI IP-100, Инструкция по эксплуатации

Страница: 21 / 79

– 18 –
The No. of pcs. counter counts up the number of finished products every time the machine performs thread
trimming. (0
→
1
→
2 ...........
→
9999)
4-4. No. of pcs. counter
The value on the No. of pcs. counter can be modified
using counter value setting switches 笳 and 笘 . The value
on the No. of pcs. counter is reset to "0" by pressing
counter reset switch
笆
.
The re-sewing switch is used when the bobbin thread runs out during the programmed stitching pattern sewing
steps or the like.
4-5. Re-sewing switch
To return to the first step of the programmed
stitching pattern without using re-sewing
switch
笊 , depress the back part of the pedal
to actuate the thread trimmer. This makes the
operation panel give the step indication 1.
Now, you can start sewing from the first step
of the programmed stitching pattern.
Step 4
D
C
B
A
Step 3 Step 1
Step 2
紆
紂
糴 糶 糺
Cau tion
笆 笳
笘
1) The bobbin thread runs out during the operations steps
for sewing. 糴
2) Bring the pedal to its neutral position to make the
sewing machine stop. Now, depress the back part of
the pedal to make the thread trimmer actuate.
糶
3) Turn ON re-sewing switch
笊
.
糺
4) Replace the bobbin. Slightly feed the material on the
machine in the reverse direction to return the material
to the position where the sewing was interrupted to
allow the sewing machine to sew over the finished seam
in step 2.
紆
5) Depress the front part of the pedal until stop position
紂
of step 2 is reached.
6) Turn ON re-sewing switch 笊 again at position 紂 where
the sewing has been interrupted, and the next step will
be indicated on the operation panel. Now, you can re-
start sewing of the programmed stitching pattern.
* If the needle thread breaks or any other trouble occurs,
which is caused by re-sewing switch 笊 during the
operation steps (
紆 → 紂
) in the free sewing mode, bring
the pedal to its neutral position, Then depress the back
part of the pedal to actuate the thread trimmer. Thread
the machine head and slightly feed the material in the
reverse direction, and press re-sewing switch
笊 . This
enables the sewing machine to continue the sewing under
the free sewing mode. Then operate the operation panel
as described in the aforementioned steps 5) and 6).
笊