BATTERY CHANGE IN THE CONTROL
ADVICE FOR BATTERY CHARGING
The battery compartments are hou-
sed in the back of the control (see
left image). Remove the covers and
insert two alkaline “AAA” batteries
in each compartment. Pay special
attention to the polarity indicated in
each compartment.
Remove the battery compartment that is in the back of the drone.
Connect the USB charger to the port of a PC and the red light on the charger lights up. Now
connect the other end to the battery connector. The light will remain on throughout the load,
turning off when the load has been completed. The estimated load time is 120 minutes.
Re-insert the battery into the drone compartment and close the lid.
ATENÇÃO: Do not use microSD port at the side of the drone to charge the battery.
Please note the following advice:
1. If you will not use the drone for a long time, disconnect the battery.
2. During charging, ensure that the charger supports the voltage of the country.
3. The charging connector may overheat if there is overload of the battery.
4. In case of battery overload, stop charging immediately.
5. Do not charge the battery without removing it from the drone.
6. Charge the battery only with USB charging equipment.
7. Before charging the battery, wait 30 minutes to cooldown. Recharge a hot battery might
generate irreparable damage.
8. Do not expose the battery to fire or to sunlight.
9. Do not cause a short circuit in the battery.
10. For child safety, avoid letting your battery near the metal parts.
Battery compartment lids
4 “AAA” alkaline 1.5V batteries
ATTENTION: 1.Make sure you put the batteries in the correct position considering the polarity
indicated. 2. Do not put the batteries in reverse. 3. Do not mix new and old batteries. 4. Do
not mix batteries of different types.
3
1
USB charger
2
