5
WARNINGS
ACROBATIC FLIGHT
THIS DRONE INTEGRATES GYROSCOPE. CAREFULLY READ THE FOLLOWING INSTRUCTIONS
BEFORE YOU START TO FLY.
1. Place the drone on a horizontal surface and press the power button. The LEDs flash slowly.
The LEDs shine rapidly during calibration or when the drone is not on a horizontal surface
when it will be turned on.
2. Turn on the control. It lights up a red light and sounds 3 beeps. The LEDs of the drone at
this time, blink rapidly. Then it lights a green light on the control and the LEDs illuminate
the drone steadily.
3. To turn on the engines, push both levers simultaneously down and out (diagonally to the
outside of the control). The drone start the engines and the propellers start spinning slowly.
Now you can push the power lever to start flying normally.
4. If the battery has been disconnected, you must restart the control to synchronize it with the
drone again (steps 1 and 2). After that, the drone will be ready to fly.
5. Basic concepts: The drone operates at a frequency of 2.4 Ghz and can be controlled over
long distances. This frequency allows the drone to fly close to other electronic equipment
without risk of interference. The drone can: move upward, downward, forward, backward,
move right or left and rotate on its axis in both directions.
6. To run an aerobatic see “aerobatic flight” section. You can run loops forward or backward
and rolls to the right or left.
7. To fly in the absolute control mode read the “ABSOLUTE CONTROL MODE” section. This lets
you fly the drone in any direction without a certain position to determine the orientation
of the drone.
8. To make the return of the drone automatically, see the “AUTO RETURN” section. When the
drone is at a certain distance, you can press this button to bring it back to the starting point.
To do exit this mode, press the button again.
9. Height measurement function: When you take off, accelerate slowly to prevent the drone
takes off with jumps. By accelerating too fast, it can cause a slow response from the drone
due to air pressure, causing an incorrect reading of the barometer.
10. To land safely, read “LANDING MANUAL".
11. If the drone crashes into an object during the flight and you need to stop quickly, press the
“emergency stop” button. Use this function careful to avoid accidents.
12. Low Battery Warning: When the drone’s battery is exhausted, the LED lights start flashing
quickly. Note: In our tests, the flash started 7 minutes of flight, but the battery life reached
12 minutes. When the battery runs out, the drone lands automatically.
To perform aerobatic is required to fly at an altitude of at least 2 meters. Press the stunt button
(see page 3) and the control will emit an intermittent beep continuously until you move the right
lever in the chosen direction (forward or backward to perform loops, right or left to perform
rolls).
Looping forward
Roll left
Looping backward
Roll right
