JTS UF-20TB/5, Инструкция по эксплуатации

Страница: 16 / 40

16
English
1) Call up the setting for the ID No via the menu
item
Device ID
of the main menu
Device ID
1
ID : ON
Fig. 8
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button 
to deactivate the function (OFF) or the button
 to activate the function (ON) If the function
has been deactivated, the REMOSET transmis-
sion will be possible from any UF-20R/5 or
UF-20S/5 receiver; if the function has been ac-
tivated, the REMOSET transmission will only be
possible from a receiver with the same ID No
4) Press the button SET to save the setting
– REMOSET transmission –
Press the button REMOSET on the receiver As
soon as the pocket transmitter has been set to
the transmission frequency or to the group and
the transmission channel of the receiver, the LED
REMOSET (3) shows blue for five seconds and
the display indicates
Sync...
If the LED REMOSET does not light up, the
automatic synchronization of the transmitter has
failed In this case, the button REMOSET on the
receiver keeps flashing slowly For troubleshooting
see steps 1 – 6 at the beginning of this chapter
Check the settings on the transmitter and possibly
on the receiver and correct them Then press the
button REMOSET on the receiver again
– Disabling the REMOSET function –
The REMOSET function can be disabled to pre-
vent automatic setting:
1) Call up the menu item
Remoset
in the main
menu
Remoset
ON
OFF
Fig. 9
2) Press the button  to disable the func-
tion (OFF) or the button  to enable the
function (ON)
3) Press the button SET to save the setting
3.7.2 Setting the frequency manually
1) Call up the frequency setting via the menu
item
Frequency
of the main menu
Frequency
604 .375
G:-- C:--
Fig. 10
2) Press the button  or  to set the frequency
in steps of 1 MHz
3) Press the button SET so that the digits after the
decimal point are highlighted To make a fine
adjustment in steps of 0 025 MHz, press the
button

or

If the frequency is identical
to the frequency of a channel in a group, the
group and channel numbers are indicated in
the lower line
4) Press the button SET a second time to save
the frequency selected
3.7.3 Selecting a frequency from a group
1) Call up the group and channel selections via
the menu item
Group/Chan
of the main
menu
Group/Chan
G: 2
C: 1
530.375 MHz
Fig. 11
2) Press the button  or  to select the group
3) Press the button SET to highlight the channel
number Then press the button  or  to se-
lect the channel The corresponding transmis-
sion frequency is indicated in the lower line
4) Press the button SET to save the setting
3.8 Adjusting the transmission power
1) Call up the menu item
RF Power
RF Power
High
Low
Fig. 12
2) Press the button  for the setting
Low
or the
button  for the setting
High
High
= high power (50 mW): high range, but
short battery life
Low
= low power (10 mW): long battery life,
but short range
3) Press the button SET to save the setting