TOOL MOUNT ADJUSTMENT SCREW
Most tool mounts are designed to fit snugly over the workstation rails. With the
locking levers in the lowered (locked) position, you should not be able to remove
the saw from the Mounting Beams of your workstation. If your power tool can be
removed when the levers are locked, the tool mount adjustment screws on the Rapid
Clamp Tool Mounts need to be tightened. Also, if your tool will not fit over both rails,
the bracket adjustment screws need to be loosened.
CAUTION:
THE SAW SHOULD BE REMOVED AND UNPLUGGED FROM
THE TOOL MOUNTS BEFORE ATTEMPTING TO TIGHTEN OR LOOSEN
THE TOOL MOUNT ADJUSTMENT SCREWS.
ADJUSTING THE RAPID CLAMP TOOL MOUNTS
1. Use a wrench to slightly loosen the nut.
2. Turn the screw with a Philips screwdriver. Rotate clockwise if the tool mount assembly
needs to be tightened or counter-clockwise if the assembly needs to be loosened.
3. Install the tool mount on the REDLEG™ 60" Miter Saw Station rails and lower the
locking lever to check the adjustment.
4. When the correct position is achieved, tighten the nut with a 10 mm open-ended
wrench to secure.
5. Repeat Steps 1-4 to attach the second tool mount.
10
