PAGE 10
SCENECONTROL 100 OPERATING INSTRUCTIONS
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 3: October 7, 2009
parameter will pop up the user name and password entry fields. Once the operator is logged in
are identified below for
fixe
lculated into target moves for
en moving do
button used with system level privileges. Once a numeric value has been entered in the
POS field, effectively updating the
ed syste
page for this winch. For winches equipped with load
ed to access parameters related to load sensing.
AD SENSE PARAM PAGE
PAGE button at
System-level privileges are required to change system parameters. These are indicated by the letter (S) following
their descriptors. If an operator is not logged in, or is logged in with user-level privileges, touching a numeric entry
field for a system
with the appropriate privileges, touching the field will cause the numeric keypad will pop up to permit a new value
to be entered.
The system parameters are accessed by for maintenance purposes only. These
reference purposes only.
POS: Display field, indicating the position of the batten as held in the control system.
UP OFST: (fixed-speed winches only). The up offset is the stopping distance calculated into target moves for the
winch when moving up, in decimal feet.
DN OFST: (
d-speed winches only) The down offset is the stopping distance ca
the winch wh
wn, in decimal feet.
NEW POS:
Entry field used with system level privileges to set a new position.
MAX SPD: (variable-speed winches only) The maximum speed of the winch, in feet per minute.
MIN SPD: (variable-speed winches only) The minimum speed of the winch, in feet per minute.
POS UPDATE: Touch
NEW POS field, the POS UPDATE button is touched to load this value into the
position of the piece.
On fixed-spe
ms, there will be two additional system level entry fields.
UP OFF:
The stopping distance (offset) for the piece when traveling in the up direction.
DOWN OFF:
The stopping distance (offset) for the piece when traveling in the down direction.
The BASE PAGE button is used to return to the motor base
sensing, the LOAD SENSE PARAM PAGE is us
LOAD SENSE PARAMETERS PAGE
Some winches are equipped with load sensing.
Load sensing parameters can be accessed by
first opening the winch’s parameter page, then
pressing the LO
button. This will open the load sensing
parameters page.
The load sensing parameters page displays
certain winch values, and provides a place where
an authorized user can manipulate them. The
BASE PAGE jump button at the bottom right of
the screen will return to the winch base screen,
while the PREVIOUS PARAM
the bottom left of the screen is used to return to
the main winch parameters page..
