PAGE 5
SCENECONTROL 100 OPERATING INSTRUCTIONS
System Operation
BASE SCREEN – MULTIPLE WINCH SYSTEMS
The Scenecontrol 100 can be used to operate
multiple winches from a single control station. In
multiple winch systems the first screen that
appears on power-up is a winch selection
screen.
An area at the top right of this screen will be
green and display the message ESTOP OK if
the emergency stop system is healthy. This
area will turn red, and the legend ESTOP
FAULT will appear when there is an emergency
stop condition. The touchbuttons in the left
column of this screen may be used to select the
desired machine for operation. Touching one of
the selection buttons calls up the base page for
that winch. The winch may then be operated as
explained in the following sections of this
manual. In systems equipped with load sensing, an indicator to the right of each winch selection touchbutton
to control only one winch, then that winch’s base page will appear on power-up, as no
T if
en. The fields below
set batten
the ENTER key on the keypad, the new value will be transferred to the TARGET field, and the keypad will close.
shows whether load sensing is on or off for that winch.
The function of the SYSTEM PRESET PAGE button is covered in a later section of this manual. If the
Scenecontrol 100 is set up
selection page is needed.
WINCH BASE SCREEN
Each winch controlled by the system has a
base screen associated with it. An area at the
top right corner of the screen will be green and
display the legend ESTOP OK if the
emergency stop system is healthy, or will turn
red and display the message ESTOP FAUL
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 3: October 7, 2009
an emergency stop button has been pressed.
The name of the selected set will appear in the
upper center of the scre
this label are as follows:
POS (ft): Set position field. The position field
displays the current position of the
(in decimal feet above the stage floor).
TRGT (ft): Set target field. When the base
screen opens up, the current position will also be displayed in the target field. To designate a new target, touch
the TARGET numeric field. A numeric keypad will open; use it to key in a new numeric target. When you touch
