PAGE 8
SCENECONTROL 100 OPERATING INSTRUCTIONS
Verify that the preset number, description, target and speed are all correct. Once this is done, touch the PRESS
TO RECORD button. The prompt “ARE YOU SURE?” will appear, along with YES and NO buttons. Press the
YES button to save the preset, or the NO button to stop the save process.
The username and password will automatically log off after five minutes, to prevent unauthorized use. Touch the
BASE PAGE button at any time to return to the winch base page.
STATUS PAGE
Touching the STATUS PAGE button on the winch base screen will open the status screen. This screen contains
indicators and displays to show the status of the winch and its associated inverter drive. The indicators on the left
and center of the screen are as follows:
MOTOR TURNING: Green if the motor is in
motion, grey if it is not moving
DRIVE READY: Green if there is power to the
drive, grey if the drive is not powered.
REFERENCED: Green if the drive is
referenced (ready to operate), grey if it is not
referenced.
AT TRGT POS: Green if the winch is at its
target position, grey if it is not at target.
BRAKE RELEASED: Green when the motor
brake is released (winch in motion), grey when
it is applied (winch stopped).
UP LIMIT: Red when the winch is on the up
limit switch, green if it is not on the limit
DOWN LIMIT: Red when the winch is on the down limit switch, green if it is not on the limit.
FAULT/WARNING: Red when there is a drive fault or warning, grey otherwise. In case of a fault, the drive must
be reset before it can be referenced for operation can occur.
DRIVE RESET: Touchbutton used to reset the inverter drive after a fault or warning has occurred and the
condition has been cleared.
The Displays at the top of the screen are as follows:
POSITION: Shows the current height of the winch batten in decimal feet above the reference point.
TARGET: Shows the target height for the winch batten in decimal feet above the reference point.
CURRENT: Shows the amperage draw of the inverter drive as a percentage of its full load current.
The BASE PAGE jump button is touched to return to the winch base Screen.
Some of these indicators are only active during winch operation; however, it is not possible to initiate winch
motion while on this page. To monitor the status of an indicator, switch to the motor base page, start motion by
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 3: October 7, 2009
