JRC NWZ-4610, Инструкция по эксплуатации

Страница: 56 / 120

4-34
4.9.2. Setting a model
This display unit is set in the MID display unit.
When the model is set, the setting contents are initialized.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Select “DISPLAY TYPE” by using and press .
3. Select “MID” by using and press .
4. When the following popup menu is displayed, press “YES”.
When “NO” is selected, the model setting is cancelled.
4.9.3. Selecting a dimmer unit
Specify whether an external dimmer unit (NCM-227) or a dimmer key is used for controlling the dimmer
unit of this display unit.
When an external dimmer unit is used, the contact input must be set to “DIMMER”. For the setting
method, see “4.9.6 Setting a contact port”.
When sharing a dimmer unit, set the same dimmer unit for the display units that share the dimmer unit.
Unless the same dimmer unit is set, linking cannot be performed.
To calibrate the external dimmer unit, refer to "7.1 Calibration of External dimmer unit "in service
manual.
Procedure
1. Refer to “4.9.1 Changing to a maintenance mode” to display the maintenance menu.
2. Select “DIMMER” by using
.
3. Select a dimmer unit by using and press .
・ When "LOG" is selected wrong, the following messages appears.
After the messages appears, press and for 8 seconds. The message is canceled.
Then, select "MID" again in the previous procedure.
・
Don't turn off the power supply until the "INITIALIZING" disappears.
Caution
Please turn on
the power again.