JRC Alphatron LT-3100 Iridium, Руководство по установке и эксплуатации

Страница: 24 / 52

24 | Installation and Mounting
Bracket mount installation procedure:
1. Fasten the bracket mount to a tube (max. 2.5" tube) by using the two V-bolts and the M8
prevailing nuts, as illustrated in Figure 14 (max torque = 5.5 Nm)
2. Screw on the LT-3130 Antenna Unit and secure the antenna lock pinot (max torque = 1.2 Nm)
3. Fasten the coaxial cable to the LT-3130 Antenna Unit (N connector)
4. Apply self-volcanic tape on the N connector and cable to protect against saltwater and
corrosion
NOTE
Always fasten the Bracket Mount, Antenna Unit (1.5" to 2.5" tube) to the tube,
before installing the LT-3130 Antenna Unit (the antenna unit and bracket mount are
fastened together by the thread lock). Remember to secure the pinot screw after
the antenna unit has been fastened. The torques are specified in Figure 14.
NOTE
The Bracket Mount (1.5" to 2.5" tube), Antenna Unit interfaces to a tube of
maximum 2.5" (63.5 mm), measured outer diameter
The Bracket Mount (1.5" to 2.5" tube), Antenna Unit can support tubes in the interval 1.5" to 2.5".
The torques are specified in Figure 14. The bracket mount, V-bolts, and nuts are made of A4 stainless
steel.
Figure 14: Bracket Mount (1.5" to 2.5" tube), Antenna Unit – horizontal tube mount