::
CHAPTER 2
DIAGNOSTIC CAPABILITIES AND
OPERATION MODES OF DIADENS-T
AND DIADENS-DT DEVICES
2. PURPOSE AND APPLICATION OF SCREENING PROGRAM
The SCREENING program is intended for the rapid assessment of homogeneity of electrical resistance of the skin zone
(ERSZ) before and after DENS treatment. One measurement of the surface resistance of the skin is made within the first
five seconds after the device is applied.
The energy range is either minimum (
(electrodes are
moved to another position after an audio signal sounds). The SCREENING program operates at frequency of 10 Hz. Only
in-built electrodes are used in the process.
To enter the SCREENING program, switch on the device. Press FREQUENCY- button repeatedly until the word
SCREENING appears on the screen. Place the electrodes onto the selected skin zone. Set the level of intensity by pressing
the INTENSITY* button until the patient experiences a light pleasant tingling sensation.
Upon application of electrodes on the skin surface the device automatically starts to measure the change in electrical
resistance on the skin in this zone in response to the impulse of the device.
After the measurement process the device emits a short audio signal and shows the measurement results on the screen in the
form of ALT index (from 0 to 100). Write down the shown number and move on to diagnostics of the next zone.
Latent
s are the skin zones where the ALT value is significantly different from the mean value on both sides.
After assessing the value of the zone, the affected zones should be treated in the
program for a period from 3 to
5 minutes at frequencies of 60 or 77 Hz at the second (comfortable) intensity level.
Содержание DiaDENS-DT
