9
www.jperkinsdistribution.co.uk
power Supply and fInal Safety checkS
POWEr SUPPLy
LiPro Quad 6 comes with male 4mm Bullet connectors attached to the power INPUT cables. These
cables are appropriate for attaching directly to most high quality AC-DC power supply units. Also
included are large crocodile clips with matching 4mm female bullet connectors, for attaching directly
to 12V DC batteries. It is important that you use a high quality AC-DC power supply in the range of 12V
to 15V DC output, with minimum current rating of 20A to insure reliable performance.
fInaL ChECKS BEfOrE COnnECtIng thE BattEry
Important!
Before connecting a battery it is absolutely essential to check one last time that you
have set the parameters correctly. If the settings are incorrect, the battery may be damaged, and
could even burst into flames or explode. To avoid short -circuits between the banana plugs, always
connect the charge leads to the charger first, and only then to the battery. Reverse the sequence
when disconnecting the pack.
Balance socket:
The balance wire attached to the battery must be connected to the charger with the black wire
aligned with the negative marking. Take care to maintain correct polarity! (Wiring diagram: see
below.)
This diagram shows the correct way to connect your battery to the LiPro Quad 6 while charging in the
balance charge program mode only:
1
2
3
4
5
6
+
S
2
+
S
1
+
S
3
Warning!
failure to connect as shown in this diagram will damage this charger!
