Joyello JL-1050 SECURFIX BRUUM, Руководство пользователя

Страница: 27 / 76

27
GB
W) Adult seat belt buckle
X) Instruction manual pocket
Y) Car seat release button
Z) ISOFIX connectors
WARNING! THIS CHILD CAR SEAT CAN ONLY BE USED WHEN INSTALLED WITH THE SEAT
BASE. NEVER INSTALL THIS CAR SEAT ONTO A VEHICLE SEAT WITHOUT THE BASE.
INSTALLING THE BASE-WITH A SEAT BELT
Please note: that your car seat is designed to fit only with a 3 point lap and diagonal seat belt and
must not at any time be fitted using only a 2 point lap belt (1).
IMPORTANT! Only use the red adult seat belt guides(G)and no other load bearing points. Check
if the adult seat belt buckle is forward of the seat belt guides (G) on the car seat, or is in a position
that interferes with the seat belt fixing points, as it may not be possible to get a secure installation
of the car seat. If this is the case, please try another seating position in the vehicle. If in doubt
please contact our customer service department.
WARNING! Always give preference to using the rear seats of your vehicle even if your highway
code permits the use on the front seat. Check the vehicle manual for advice on fitting your car seat
in the front of the vehicle.
WARNING! AIRBAGS CAN CAUSE INJURY. DO NOT USE THIS CHILD SEAT ON A PASSENGER
SEAT FITTED WITH A FRONTAL AIRBAG.
Ensure the ISOFIX points are fully retracted. To do this, squeeze together the ISOFIX adjustment
buttons (R) located on either side of the support leg at the front of the car seat base, and pull the
support leg towards you.
Unfold the support leg fully and place the car seat base onto the vehicle seat (1).
Open the central red belt lock (H) (2). Pull the vehicle seat belt pass across the belt locker of the
base (3).
Pass the lap section under both belt guides (G) make sure it also passes through the belt lock (4).
Ensure that the seat belt is pulled tightly and is not twisted. Then close the belt lock to secure the
seat belt in place (5).
WARNING!
NEVER fit the car seat belt in any way not mentioned in these instructions.
IMPORTANT! Always use the support leg when the car seat base is fitted into the vehicle.
WARNING! Ensure that at all times the support leg is in contact with floor of the vehicle and the
indicator is green. to adjust the support leg, squeeze the RED support lock (T) located on the of
the support leg and extend the lower section of the support leg until it reaches the vehicle floor
(10). When the support leg is locked into position the indicator will turn green. If the lock does not
engage, extend the leg to the next lock position.