5. USAGE OF DEVICE
1. Adjusting of current
Through the spinning clockwise of the regulator, the current
increases and with spinning counterclockwise, the current
decreases.
2. Adjust the status of the LED display
Press “SET“ to adjust the status of the LED display. Press again
“SET“ to display the current (0.00 A), power (00.0 P) and voltage
(00.0 V).
3. Load output open and close
Press “OK“ to open and close the load output.
4. Adjusting the load output at the start
Hold down the “OK“ button to switch the load output with the next
start on or off.
display for activated load
at the start
display for deactivated
load
6. TRIGGER FUNCTION
The trigger / decoy function is the function to start the quick charger of the
charging unit. In this mode the load can not be switched on or off but the
current of the load can still be adjusted with the potentiometer
(except in the AUTO mode because all other modes are sending only trigger
instructions and do not evaluate if the trigger is successful or not).
This mode complies the different display statesin the trigger mode:
QC2.0 5V: display shows “-05.0“ (red LED glows)
QC3.0: display shows current voltage (green LED glows)
