10
c.
MIX
In EDIT mode, once you’ve set TIME and Fb feedback, adjust the mix volume of the delay to
your preferred mix level using (Bypass-) and (Tuner+) buttons. Set MIX to all numbered lights
off to completely turn off the Delay effect.
With the combination of TIME, Fb, and MIX settings, you can set your prefect Delay effect.
6.
REVERB
In the EDIT mode, use (on/off
3
) and (
4
store) buttons to cycle to the REVERB mode. Then use
(Bypass-) and (Tuner+) buttons to increase or decrease the wetness of the Reverb with 1 as the
minimum and 10 as maximum level settings. As you increase brightness, the lights are illuminated from
1 up to the brightness you’ve selected.
7.
IR Cab Mode
The HA01 comes with 10 preset IR Cab simulations. To select your IR Cab, in the EDIT mode, use
(on/off
3
) and (
4
store) buttons to cycle to the CAB mode. Then use (Bypass-) and (Tuner+) buttons to
make your CAB selection. Below are the initial default IR Cab settings native on the device. (Please note
these may be subject to change, so check the product page on our website for the most recent CAB
selection.)
8.
VOLUME Adjustment
Volume Adjustment works the same for PRESET and EDIT modes. Use (Bypass-)
and (Tuner+) buttons to increase or decrease the volume with 1 as the minimum
and 10 as maximum level settings. As you increase volume, the lights are
illuminated from 1 up to the brightness you’ve selected.
©Copyright 2021 Journey Instruments Limited
