6
Installation
Installation of the crank
Install the special crank (1) on the right landing gear.
To do this, remove the cable tie (not illustrated - used for
transport protection). Note that the spring (5) is under ten-
sion due to the cable tie.
Push the guide ring (3) that is on the crank onto the crank
drive (6).
Then push the adjusting ring (2) onto the crank drive and
secure it in the hole provided using a clamping sleeve.
Then, with the crank inserted, check that it is certain the
crank drive is pressed to the high gear position by the spring.
ADVICE!
Tighten all screw connections to a tightening torque of
190 + 10 Nm.
WARNING!
If there are bracings on the landing gear, these
must be installed in the same way or attached
according to the illustration on initial installation.
Beware of the danger of crushing when working
with the components to be installed!
20
MUB 006 001 M01
(REV-D)
07-2020
Modul E-Drive
