Ergo Caboose Instruction Manual
Using the Stroller as an Infant
Car Seat Carrier Support
• Locate the car seat carrier support and orient it with
the curve of the tubing facing downward. See Figure
37.
• Insert each end of the tubing into the rear of each
child handle until BOTH spring snaps lock securely
into place with an audible click. See Figure 38. Pull
the bar towards the rear of the stroller to ensure it is
secure.
NOTE: Car seat carrier support WILL NOT fit unless it
is installed correctly.
• Extend the front support bar towards the front of the
stroller and insert one of the metal pins into the side
rail of the stroller. See Figure 39.
NOTE: Be sure that the side fabric supports are
not twisted. Then, gently squeeze the tube on the
other side of the support bar towards the middle of
the stroller just enough to allow the metal pin on that
side to be inserted the same way. Visually check and
gently pull up on the front support bar to ensure it is
inserted properly.
• Remove the infant carrier from the car seat base.
• Place the infant carrier onto the top of the stroller in
the REAR FACING POSITION, locating the head end
of the carrier so it rests on the front support bar and
the feet end of the carrier so that it rests on the rear
support bar. See Figure 40.
• Ensure that the carrier is secured firmly on BOTH
support bars and that It is centered from side to side.
• Locate the carrier restraint straps on both sides of the
fabric side supports. Buckle them over the LOWEST
part of the carrier sides. See Figure 41. Adjust the
straps so they are tight around the carrier, but AWAY
from the child’s neck. Pull up on the carrier to be
sure it is installed securely.
• Always check frequently to be sure that the restrain-
ing straps are tight across the infant carrier but away
from the child’s neck.
Figure 38
Figure 39
Figure 40
Figure 41
Pg. 12
Figure 37
