Ergo Caboose Instruction Manual
Installing and Operating the
Canopy
• To attach the canopy, position the canopy on the
stroller with the visor extension forward.
• Line up the male fittings on the canopy with the
female fittings just above the hub near the center
of the stroller and push downward until the fittings
snap into place. See Figure 9.
• Open the canopy by pulling forward on the front
edge while holding the back edge in place.
• The canopy and visor can be adjusted into several
positions ranging from fully closed to full extended,
or any position in between.
• The visor can be opened (or closed) by pulling (or
pushing) it from under the canopy. If you do not
wish to use the sun visor, simply push it completely
under, or over, the canopy where it will stay.
• To use the rear canopy extension, attach it by
inserting the zipper pin into the zipper slider. See
Figure 10. Completely zip the rear canopy exten-
sion to the opposite end of the zipper so it is fully
attached.
• Once the rear canopy extension is attached, pull
each of the upper rear canopy attachments toward
the rear handle and attach the button holes to the
extended rivets on the sides of the handle bar
between the foam and the folding triggers. See
Figure 11.
• Then, locate the lower elastic loops at the bottom
rear of each side of the canopy. Pull them back
to the inside edge of the rear child handle and at-
tach them to the extended posts on the rear child
handles. See Figure 12.
• To remove the rear canopy extension, detach
the upper and lower rear attachments from the
extended rivets and posts and completely un-zip
the extension.
• To remove the canopy, press the lock button on
the side of each of the male fittings while pulling
upward on the canopy frame. See Figure 13.
Figure 9
Figure 10
Figure 11
Figure 13
Figure 12
Pg. 4
