Caboose Stand-On Tandem Instruction Manual
Folding the Stroller
• Keep children away from stroller while folding.
• Remove any infant carrier that has been installed on the stroller. Note that the stroller
can still be folded with the car seat carrier support in place.
• Position the stroller with the handle bar closest to you.
• Place the canopy into its closed position and push it all the way forward toward the
front of the stroller as far as it will go.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock both front wheels in place with the locking levers facing forward.
• To fold, unlatch the safety latch on the lower left side of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller. See Figure 31.
• While these mechanisms are in the upward position, push forward on the stroller
using the handle bar.
• Once the stroller begins to fold, push the handle all the way forward and down
until the stroller is completely folded. See
Figure 32.
CAUTION: While folding the stroller, be
careful to keep your fingers from being
pinched by moving parts.
• Secure the stroller in the folded position
by engaging the locking latch on the right
side of the stroller over the extended
rivet. See Figure 33.
Figure 31
Page 13
Page 14
!
IMPORTANT NOTE
When using your stroller as an infant car seat carrier, the
following are the compatible infant car seat models that
the Caboose Stand-On Tandem will accommodate:
For the most updated list of compatible infant car seats, please either check our website
at
www.joovy.com
or call our Customer Service Department at (877) 456-5049.
•
Baby Trend® Latch-Loc and Flex-Loc
•
Britax® Companion™
•
Chicco® Key Fit Car Seat
•
Combi® Centre Series
•
Combi® Connection
•
Compass® Light and Portable Infant
Car Seat
•
Eddie Bauer® Infant Car Seat
(models 22-625 and 22-626)
•
Evenflo
® Embrace™
•
Graco® Safe Seat™
•
Graco® Snug Rider™ Series
•
Maxi Cosi Mico
•
Peg Perego® Primo Viaggio
•
Peg Perego® Primo Viaggio SIP
•
Safety 1st® Designer 22™
