Caboose Stand-On Tandem Instruction Manual
• Push the axle as far as it will go toward the opposite side of the stoller, then repeat
the installation steps for the other wheel.
• Install a hubcap onto each wheel by aligning the 5 tabs on the hubcap with the 5
slots in the wheel, and then pushing it into place. Ensure that ALL 5 snaps have
engaged securely and the hubcap cannot be pulled off. See Figure 7.
Figure 4
Figure 5
Figure 6
Figure 7
Installing the Front Wheels
• Take one of the double wheel sets and
locate the small hole in the rotating
bracket that is inside the red lever.
• Push the front axle into this hole and
keep pushing the wheel set onto this
axle until you hear an audible click.
See Figure 8.
• Pull downward on the wheel set to
ensure that it has locked into position
on the axle.
• Repeat this same procedure for the
other wheel set.
• When assembled properly, both wheel
sets should rotate and roll smoothly.
Figure 8
Page 3
Page 4
