Caboose Stand-On Tandem Instruction Manual
Figure 28
Figure 29
Figure 30
Using the Stroller as an Infant
Car Seat Carrier
• To use the stroller to carry an infant
car seat carrier, you must replace
the Front Tray with the Car Seat
Carrier Support.
• Remove the Front Tray by pressing
in on the lock tabs and pulling the
tray off the brackets. Store the tray
in a convenient place for later use.
• Line up the female fittings on the
Car Seat Carrier Support to the
male fittings on the front of the
stroller and push inward until the
fittings snap into place. See Figure
28. Pull outward on both sides of
the support to be sure both are
snapped securely in place.
• Push the canopy to its most
rearward position.
• ADJUST THE SEATBACK TO ITS
RECLINED POSITION.
• Remove the infant carrier from the
car seat base.
• Place the infant carrier onto the top
of the stroller in a REAR FACING
POSITION, locating the head end
of the carrier so that it rests on the
Car Seat Carrier Support and the
feet end of the carrier so that it
rests on the seatback, but NOT on
the top edge of the seatback. See
Figure 29.
• Ensure that the head end of the
infant carrier is pushed down firmly
INSIDE the frame of the Car Seat
Carrier Support and that it is centered side to side.
• Remove the carrier restraining straps from the pouches on both sides of
the stroller. Buckle them in place over the LOWEST part of the carrier sides.
Adjust the straps so they are tight around the carrier but AWAY from the
child’s neck. Pull up on the carrier to be sure it is held on securely. See
Figure 30.
• Always check frequently to be sure that the restraining straps are tight
across the infant carrier but away from the child’s neck.
• When you remove the infant carrier from the stroller, always replace the two
restraining straps back into their side pouches.
Page 11
Page 12
