![background image](http://html.mh-extra.com/html/jonsered/fr-2213-ma/fr-2213-ma_workshop-manual_2026379041.webp)
7. Turn the screws right or left until the ground
pressure is between 12 and 15 kg (26.5-33 lb).
8.6.4 To adjust the parallelism of the cutting deck
1. Remove the front cover and the right footrest plate.
2. Remove the screws that hold the belt shield and
remove the belt shield.
3. Loosen the nuts on the lift strut.
4. Turn the lift strut to extend the stay or make it
shorter. Extend the stay to lift the rear edge of the
cover. Make the stay shorter to lower the rear edge
of the cover.
5. Tighten the nuts on the lift strut when the adjustment
is done.
6. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
7.
7. Attach the belt shield and tighten the screws.
8. Attach the right footrest plate and the front cover.
8.6.5 To adjust the cutting height
1. Make sure the cutting height stay is attached to the
cutting deck.
2. Put the cutting height lever in the lowest cutting
height position.
3. Remove the right footrest plate. See
covers on page 16.
4. Adjust the stay for the cutting height adjustment until
there is no play between the cutting deck and the
cutting height stay.
5. Do a check of the parallelism of the cutting deck.
See
To do a check of the parallelism of the cutting
deck on page 7. Adjust the parallelism if it is
To adjust the parallelism of the
6. Do a check of the ground pressure of the cutting
deck. See
To examine and adjust the ground
pressure from the cutting deck on page 40.
659 - 001 - 11.04.2018
Repair instructions - 41
Содержание FR 2213 MA
Страница 1: ...Workshop manual FR 2213MA FR 2216MA FR 2216MA 4x4 English 659 001 11 04 2018 ...
Страница 54: ...54 Technical data 659 001 11 04 2018 ...
Страница 55: ...659 001 11 04 2018 Technical data 55 ...
Страница 56: ...www jonsered com 1159918 26 2018 07 05 ...