Jonsered FR 2213 MA, Руководство по ремонту, Страница: 23 / 56

and key are attached to the engine shaft. Put grease
on the engine shaft when you attach the engine belt
pulley.
8.2.2 To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Note: See
Technical data on page 52 for the types
of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
8.2.3 To replace the engine oil and oil filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for more
than 1–2 minutes before you drain the engine
oil. The engine oil becomes very hot and can
cause burn injuries. Let the engine become cool
before you drain the engine oil.
WARNING: If you spill engine oil on your body,
clean with soap and water.
1. Put a container below the oil drain plug.
2. Remove the drain plug.
a) If the product has an oil drain plug that can be
opened by hand, open the plastic cap on the end
of the oil drain plug.
b) Attach a plastic hose to the end of the oil drain
plug to prevent spill.
659 - 001 - 11.04.2018 Repair instructions - 23