Jonix steel 1C, Руководство по эксплуатации и обслуживанию

Страница: 43 / 96

43
JO NIX
steel
This section summarises the most common problems that may arise when using the unit. Before
contacting customer services, carry out the checks listed below.
8 - oPeRaTIonal cHecK anD TRoUblesHooTInG
PRobleM
PossIble
caUse
solUTIon
The green LED indicating device
operation is switched off.
The unit is not powered.
Check that the switch is in position “I”.
Check that the plug is connected to the mains
power socket.
Verify the presence of electricity in the
distribution network.
Check that the power socket to which the
device is connected works.
Verify the status of the fuse inside the device
(described in chap. 4 of this manual). In case
it is burnt contact the manufacturer.
No sizzling noise comes from
inside the module.
The ionising tubes are
faulty. Follow the instructions in section
“7.3 - Extraordinary Maintenance”.
The ionising tubes and
fan mesh filter need
cleaning.
Follow the instructions in section
“7.3 - Extraordinary Maintenance”.
JO NIX
steel 2C/4C/2F/4F
:
it is not heard any noise coming
from inside the module and
the LED indicating the need
for maintenance of the device
is turned on with blinking light
(yellow indicator).
The ionising tubes and
fan mesh filter need
cleaning.
Follow the instructions in section
“7.2 - Routine Maintenance”.
JO NIX
steel 2C/4C/2F/4F
:
it is not heard any noise coming
from inside the module and
the LED indicating the need for
maintenance of the device is
turned on with permanent light
(yellow indicator).
The ionising tubes need
replacing. Follow the instructions in section
“7.3 - Extraordinary Maintenance”.
It is not heard any noise coming
from inside the module and the
LED indicating damage is turned
on with permanent light (red
indicator).
The ionising tubes are
faulty.
Follow the instructions in section
“7.3 - Extraordinary Maintenance”.
The tube has to be
replaced before time.
Malfunction of an electric
component.
Consult specialized personnel.