Jolly 3500EVO/V/DD/PS, Инструкция по эксплуатации

Страница: 10 / 20

- 10 -
EN INDUSTRIAL GLASS AND DISHWASHER—USERS MANUAL
ATTENTION
The fist operation of the dishwasher MUST be performed by authorized and qualified personnel who will also give in-
structions concerning the machine.
OPERATION

Open the dishwasher door and check whether the wash arms are installed. If not, install the wash arms (see Installation
Manual) Verify that the suction filter pump is properly assembled. Insert the "overflow" pipe in the case of gravity dis-
charge or check the correct positioning of the drain pump filter. Then close the door.

FILLING AND HEATING:
1.
Pressing the switch 0/1 (1) to 1, the indicator light will turn on (1a) and the machine will make a check on the light.
After that, the machine will set into a stand-by mode (the wash cycle light (2a) and regeneration light (5a, if
foressen, blinks).
2. Pressing the cycle button (2) the machine will start to fill with water. During the filling the cycle light will blink.
3. In this state the machine has full control over the tank and boiler temperatures, so if the temperature of the boiler is
lower than the pre-set temperature, the machine will activate the boiler heating element, until when the correct
temperature is reached. The boiler heater light (7a) will be on.
4. Once the boiler has reached the set temperature, the heating element will turn off and accordingly the correspond-
ing light (7a) will turn off. Then the machine will check the wash tank preset temperature and if it’s lower, the
heating element will activate until the correct wash temperature is reached. The wash tank heating elements is indi-
cated by the corresponding light on the control panel (8a). When both temperature, boiler and tank, will be
reached, both lights (7a and 8a) will be off.

WASHING:
1.
Select the cycle by switching (6) slow / medium / fast.
2. Press the cycle button (2); the corresponding indicator light (2a) will turn on.
3. Wait until the machine has finished the cycle.
4. At the end of the cycle (light 2a off), open the door and remove the rack.

COLD RINSE BUTTON
1.
Press and hold the cold rinse button (3). Then, the indicator light will turn on (3a). The machine will now rinse
with cold water.
2. Switch off the cold rinse button (3). The corresponding indicator light will turn off.
ATTENTION
Do not open the door until the machine has finished the cycle. In case the door is opened during the cycle, the cycle will
stop. Automatically when you close the door, the cycle will continue from where it was interrupted.
ATTENTION
To achieve a good washing result, it is essential to wait until the machine has reached the correct temperatures (so when
lights 7a and 8a are off).
ATTENTION
The machines are equipped with interlock function. This device allows the machine to perform the rinse only when the
minimum set temperature is reached. If the wash cycle has started before the rinse boiler heating lamp (7a) has switched
off, then the wash cycle will continue until the set temperature is reached.
It is possible to deactivate the interlock function by modifying the DEEP SWITCH located on the electronic board (see
page 16 - deep 4 ON).