Jole Trillo LX, Инструкция по эксплуатации

Страница: 21 / 25

37 38
Without back support
see images
25
-
31
1. Adjust backrest to flat position,
then one hand to detach
backrest as
25
to use base
assembly independently.
!
Please take good care of
back support and head
support.
2. Check whether the shoulder
belt lay across child’s shoulder
in red zone
26
.
!
Must use shoulder belt
positioning clip when use
base independently.
3. Insert the end of shoulder belt
positioning Clip webbing into
the hole on the base.
27
!
Please check the direction of
shoulder harness anchor as
29
to avoid hurting child back
if shoulder harness anchor is
in the opposite direction.
!
Pull the shoulder belt
positioning clip webbing
slightly to make sure the
webbing fixed on the base.
25
27
26
29
4. Make the webbing and clip
wind round bar, then tension
webbing.
28 29
!
Slide shoulder harness
anchor to adjust webbing
length.
5. Slide the shoulder belt
positioning clip to make sure
the clip is close to child’s
shoulder,
30
-1
buckle the
vehicle safety belt.
30
-3
!
To achieve the safest
installation, we suggest the
shoulder belt positioning
clip should be level with the
highest point of the child’s
shoulder.
!
Through vehicle safety belt
out from bottom of armrest.
30
-2
!
Ensure the vehicle safety
belt is not slack or twisted.
!
The child restraint can not
be used if the vehicle safety
belt buckle (female buckle
end) is too long to anchor
the child restraint securely.
30
-4
28