5
daintree
curved shower screen
IMPORTANT INFORMATION
JohnsonSuisse
3
1
2
855 - 880mm
914×914
950 - 975mm 1000×1000
6mm
3.5×35SS
Min Max size
4
2
2
5
3
3
14
14
4
4
5
3
3
13
13
5
6
7
1 Measure your shower base/shower area. The
measurement to the outside edge of the of the wall
jambs(1) should be somewhere within the min and max
size of the screen.
Min
Max
Screen Size
855mm
880mm
914×914mm
950mm
975mm
1000×1000mm
If you are using the maximum size make sure that you allow
for walls that may be out of plumb. If you walls are 10mm out
of plumb reduce your screen area by this amount.
2 Use a level ensure jambs (1) are plumb then mark the
outside edges with pencil. Recheck measurements.
3 Remove jambs and drill 6mm holes with drill bit. Insert
the plastic wall plugs.
Note: Please use the right fixing .for the surface you are
screwing into to ensure that the jamb is fixed securely
to the wall. eg: toggle wall plug.
4 Using a level ensure jambs (1) are plumb and the holes
in the jamb line up with the holes in the wall. Fix jamb to
wall using the screws provided.
Adjust the sliding doors(4) using the screws located on the
bottom of top roller assemblies(13). Adjust rollers so that
the sliding doors (4) are parallel to the fixed panels(3) and
parallel to each other. Note: Do not overtighten top rollers
as this will cause the bottom rollers to jamb and or break.
Adjust fixed panel extrusions(2) in or out on the wall
jambs(1) so that the top rail(5) is horizontal and the
whole screen sits square on the shower base/shower
area.(B=C=D)
