Johnson J10RLSUR, Руководство по обслуживанию

Страница: 65 / 229

63
MAINTENANCE
STORAGE
3
STORAGE
IMPORTANT:
DO NOT start outboard without a
water supply to the outboard’s cooling system.
Cooling system and/or powerhead damage could
occur.
Fuel System Treatment
Stabilize the boat’s fuel supply with Evinrude/
Johnson 2+4 Fuel Conditioner following the
instructions on the container.
Prepare a “storage mixture” of fuel in a separate
outboard six gallon fuel tank. The storage mixture
should consist of:
•
5 gallons (18.9 liter) of fuel;
•
2 quarts (1.9 liter) of Evinrude/Johnson Storage
Fogging Oil ;
•
2.5 ounces (74 ml) of Evinrude/Johnson 2+4
Fuel Conditioner ; and
•
1 pint (473 ml) of Evinrude/Johnson outboard
lubricant.
Temporarily connect fuel tank with storage mix-
ture to the outboard.
Shift the remote control to NEUTRAL and remove
the propeller.
START outboard and RUN at IDLE speed for five
minutes to ensure that the entire fuel system is
filled with the storage mixture.
STOP outboard. Turn key switch to OFF position
on remote electric start models. Proceed with
Internal Engine Treatment .
Internal Engine Treatment
Use Evinrude/Johnson Storage Fogging Oil to
prevent corrosion of internal engine components
during periods of storage.
Remove all spark plugs and spray a liberal
amount
Evinrude/Johnson Storage Fogging Oil
into the spark plug holes.
Turn the flywheel in a clockwise direction to dis-
tribute the fogging oil throughout the cylinders.
Install and torque the spark plugs.
If outboard is equipped with a portable fuel tank,
disconnect fuel hose from outboard and tank.
IMPORTANT:
DO NOT restart outboard until it
goes back into service.
If the outboard is removed from boat, examine all
loosened and removed hardware. Replace dam-
aged or missing parts with genuine
Evinrude/
Johnson parts or equivalent.
Additional Recommendations
•
Replace gearcase lubricant.
•
Remove and inspect propeller.
•
Clean and grease propeller shaft.
•
Lubricate all grease fittings and linkages.
•
Clean or replace fuel filter element.
•
Inspect outboard, steering system, and con-
trols. Replace all damaged and worn compo-
nents. Refer to manufacturer’s maintenance
and lubrication recommendations).
•
Touch up painted surfaces as needed. Coat
outer painted surfaces with automotive wax.
•
Remove battery(s) from boat. Store in a cool,
dry location. Periodically charge battery(s) while
stored. (Refer to manufacturer’s maintenance
recommendations when servicing batteries.)
•
Store outboard in upright (vertical) position.
•
Check for fuel leakage.
WARNING
To prevent injury from contact with rotat-
ing propeller, remove the propeller before
flushing.
WARNING
Failure to check for fuel leakage could
allow a leak to go undetected, resulting in
fire or explosion.