10
©2012 Johnson Level & Tool
completed, press the grade axis button for two seconds to enter into the
Y-axis grade setting mode. The Y-axis symbol “Y” and axis direction
symbol (+) will flash. The setting method is the same as the X-axis.
After the Y-axis grade setting is completed, press this key for two
seconds to confirm the grade setting. The laser will beep once
and will quit the grade setting mode and start to work under the
confirmed grade.
Note: If there is no buttons pressed for eight seconds in the
grade setting mode, the laser will confirm the current grade
setting data automatically. The laser will beep once and leave
the grade setting mode.
Rotating Speed Button:
Press this button to select the rotating speed from 600 RPM
to 1100 RPM.
Beam Shield Buttons:
When turning on the laser, the beam shield will be off in all four
quadrants. All four quadrants on the LCD will be displayed. Pushing
one of the buttons will turn the beam off in that quadrant and that
quadrant will not be displayed on the LCD.
Note:
One, two or three quadrants can be turned off simultaneously.
6274H-2_Manuals 9/26/12 11:32 AM Page 10
