©2018 Johnson Level & Tool
7
Set Your Desired Unit of Measurement
When powered on, the level will default to the most recently
used unit of measurement. Tap to change the unit of
measurement.
Continue to tap to scroll through the following options:
1. Degrees
2. Percent
3. Inches/foot (decimal)
4. Inches/foot (fraction)
5. Inches/10 feet (decimal)
6. Inches/10 feet (fraction)
7. Millimeters/meter
Set Your Desired Operating Mode
Note:
The pre-programmed modes set for this level may differ from
your specific jobsite requirements. You are responsible for adherence
to all federal, state and local building codes. Johnson Level & Tool
Mfg. Co., Inc. assumes no responsibility for misapplication of this
digital level by the user.
The bottom of the main display will show the current operating mode.
When powered on, the level will default to the most recently used
mode. Press and hold to change your operating mode.
If the level’s reading exceeds the set limits for the current operating
mode (ADA, ADA X, DMV and Custom modes only), the level will
begin beeping (if the volume is enabled) and either “HI” or “LO”
will flash at the bottom right of the LCD displays to alert you that
the unit is outside of its limits.
2842i_Manuals 4/27/18 2:08 PM Page 7
