Installation
Installation safety information
About this task:
Read these instructions before continuing
this appliance installation. This is an outdoor
combination heating and cooling unit. The installer
must assure that these instructions are made
available to the consumer and with instructions to
retain them for future reference.
1. Refer to the unit rating plate for the approved
type of gas for this product.
2. Install this unit only in a location and position
of these instructions.
3. Never test for gas leaks with an open flame.
Use commercially available soap solution
made specifically for the detection of leaks
when checking all connections, as specified
Installation safety information
, and
of these
instructions.
4. Always install furnace to operate within the
furnace's intended temperature-rise range
with the duct system and within the allowable
external static pressure range, as specified on
the unit name/rating plate, specified in
of these instructions.
5. This equipment is not to be used for
temporary heating of buildings or structures
under construction.
WARNING
FIRE OR EXPLOSION HAZARD
Failure to follow the safety warning exactly could
result in serious injury, death or property damage.
Never test for gas leaks with an open flame. Use
a commercially available soap solution made
specifically for the detection of leaks to check all
connections. A fire or explosion may result causing
property damage, personal injury or loss of life.
Preceding installation
About this task:
Read all the instructions before
you perform the installation. Complete the following
steps:
1. Remove the two screws that hold the brackets
in the forklift slots on the side of the unit.
Figure 1: Unit shipping bracket
Item Description
A
Bracket screws
B
Bracket
2. Turn each bracket toward the ground. The
protective plywood covering drops to the
ground.
3. Remove the protective covering from the
condenser coil prior to operation.
Figure 2: Protective condenser covering
4. If a factory option convenience outlet is
installed, you must install the weatherproof
outlet cover in the field. The cover is located
behind the filter access panel.
a. Remove the shipping label that covers
the convenience outlet.
b. Follow the instructions on the back of
the cover box.
c. Attach the cover to the unit with the
four screws provided.
INSTALLATION MANUAL ZY SERIES 3 - 10 ton 60 Hertz R-410A
9
Johnson Controls Ducted Systems
Содержание ZY Series
