OPTIONAL PARTS
TC-16002-rev.1
3-9
3.6 Infrared (IR) Receiver Kit: C2IRK01
C2IRK01 is only available to be used in combination with the wireless controller CIR01 and the indoor unit
2-way cassette type models.
Factory-Supplied Accessories
Check to ensure that the following accessories are packed with the IR receiver kit.
● Turn OFF the power supply completely before setting the DIP switches, installation work and electrical
wiring work for IR receiver kit. Not doing so may cause an electric shock.
Installation
● When the IR receiver kit is installed near ambient lighting, it may not receive a signal from the wireless
controller. Therefore, pay particular attention to the installation position of the IR receiver kit.
● Do not run the connecting cable for the IR receiver kit and the power supply cable (208/230V) in
parallel. It may cause a malfunction of the IR receiver kit.
No.
Accessory
Qty.
Remarks
1
IR Receiver Kit
C2IRK01
1
with Connecting Cable
2
Connecting
Cable
1
-
3
Wiring Cover
1
for Protection of
Connecting Cable
4
Plastic Band
3
for Clamping Wiring Cover
and Connecting Cable
5
Installation Manual
1
-
6
Operation Manual
1
-
2
1
4
3
3
This IR receiver kit can be attached to any of four corners
(
1
,
2
,
3
or
4
).
Determine the attachment location according to the
purchaser’s request.
NOTE:
Setting the DIP switch for the IR receiver kit is possible at more
than one function. If an optional function selection is required,
perform work according to the section, “Optional Functions”,
before the IR receiver kit is attached to the decorative panel.
1
Perform the installation work for the IR receiver kit while the optional decorative panel is being attached
to the indoor unit.
2
When the IR receiver kit is attached after the decorative panel is attached to the indoor unit, turn OFF
the power supply of the indoor unit, and remove the decorative panel. Removing the decorative panel
should be performed according to the installation manual for the decorative panel or the service manual.
