Figure 1: Positioning the Unit on a DIN Rail
3. Hang the unit on the DIN rail by the hooks at the top
of the DIN rail channel (on the back of the bracket),
and position the unit snugly against the DIN rail.
4. Push the bottom-mounting clip inward to secure the
unit on the DIN rail.
Wall Mounting
The unit may be mounted using the holes in the DIN rail
clips. This orientation helps accommodate on-site
constraints. Screw hole locations are illustrated in
.
The screw types needed to mount the unit depend upon
the surface to which the unit is mounted. The screw holes
on the VRF Smart Gateway can accommodate M3.5 and
#6 screws.
For information on location considerations for maximizing
signal strength, see the
section.
Figure 2: Sample Permanent Mounting, Back-side
Screws
To mount the unit on a flat surface (such as a wall):
1. Pull the bottom mounting clip outward to the extended
position.
2. Mark mounting hole locations on the wall using the
dimensions shown in the following figure; or hold the
bracket against the wall and mark the hole locations
through the mounting clips.
Note:
The position of the location holes depends on
whether the bracket is mounted horizontally
or vertically.
3
VRF Smart Gateway Installation Instructions
