VRF Smart Gateway Installation Instructions
SI-VRFCBN02-0Sx
(barcode for factory use only)
Part No. 24-10143-1183, Rev. B
Software Release 1.0
Issued April 2017
Refer to the
for the most up-to-date version of this document.
Update Software
Important:
A software update may be available for your
device. Visit
or contact your
nearest Johnson Controls representative
for the latest version. Refer to the
VRF
Smart Gateway User's Guide
(LIT-12012385)
for instructions on applying
updates.
Applications
The Johnson Controls
®
VRF Smart Gateway enables
the integration of the Hitachi VRF system with a building
automation system (BAS), such as the
Metasys
®
system.
The VRF Smart Gateway performs this function by
communicating between the native H-Link
communications network of the Hitachi VRF system and
the open building standard BACnet
®
/IP network. The
VRF Smart Gateway intelligently provides the VRF device
and point data over the BACnet/IP network in a way that
the BAS can easily discover. The VRF Smart Gateway
therefore requires little or no post-integration configuration
within the BAS. The VRF Smart Gateway includes a
simple web server that provides a wireless mobile user
interface for configuring communication parameters and
performing VRF system discovery and device naming.
The wireless connection on the VRF Smart Gateway
allows users of a supported mobile device to be up to 30
m (100 ft, line of sight) away. Power must be supplied
using the provided external power supply.
North American Emissions
Compliance
United States
This equipment has been tested and found to comply
with the limits for a Class A digital device pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when this equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area may cause harmful interference, in which
case the users will be required to correct the interference
at their own expense.
RF Transmitters: Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure (OET Bulletin 65)
To comply with FCC RF exposure requirements for
mobile transmitting devices, this transmitter should only
be used or installed at locations where there is at least
20 cm separation distance between the antenna and all
persons.
1
VRF Smart Gateway Installation Instructions
