Johnson Controls tyco iSTAR Ultra, Руководство по установке и настройке

Страница: 46 / 118

iSTAR Ultra Network Topology
3–2 iSTAR Ultra Installation and Configuration Guide
iSTAR Ultra Network Topology
iSTAR Ultra supports communications over 10/100/1000 Mbps Ethernet networks using
TCP/IP.
LAN and WAN Configurations
The TCP/IP protocol transfers data across a number of networks. Because iSTAR Ultra
controllers use the TCP/IP protocol for network communications, they can communicate with
each other within a LAN or across a WAN, as shown in Figure 3-1.
Figure 3-1: Sample iSTAR Ultra Network
Gateways and Firewalls
iSTAR Ultra configurations provide access to remote C•CURE systems across firewalls and
Network Address Translators. This is because the master controller automatically accepts a
translated IP address if one is assigned from a remote host, or from an attached Network
Address Translator.
Generally, the TCP/IP ports, listed in Table 3-1 on page 3-2 , must be open through a firewall.
See the latest C•CURE 9000 and iSTAR Ports document available from
http://www.swhouse.com .
Ethernet
iSTAR Ultra Controllers
LAN 2
iSTAR Ultra Controllers
C•CURE System Host
Ethernet
Switch or Router
LAN 1
LAN 3
Switch
Switch
Table 3-1: TCP Ports
Port Description Protocol
Destination
System
68 DHCP client. A function of Linux and networking. UDP Network
80 Redirect to HTTPS (port 443) TCP Web
443 Secure web connection used for diagnostic website. Port is
closed in FIPS mode. Only necessary for diagnostics. TCP Web
1999 iSTAR master port for incoming non-encrypted member
connections, plus incoming ICU requests. TCP Master