Installing the NAE/NIE Technical Bulletin
19
Detailed Procedures
Mounting the NAE
Notes:
Mounting options for the NAE include wall mount, DIN rail,
and enclosure. Before you install the NAE, make sure the mounting
environment is suitable for the controller. See
Installation
Considerations
for the NAE environmental tolerances. For information
on mounting orientations and space allowances, see
Correct Mounting
Orientations
and
Mounting Space
in
Key Concepts
.
To remove the NAE from the mounting surface, follow these
instructions in reverse, after you have removed line power from the
NAE and removed the network connections.
Wall Mount
To mount the NAE on a wall (or other vertical surface):
1.
Mark the locations of the four mounting holes using Figure 11 or
by holding the unit up to the wall as a template.
Note:
Allow enough space for making cable connections to the
NAE. The proposed mounting space should be at least
408 x 303 x 148 mm (16.1 x 11.9 x 5.8 in.).
63.5 mm
(2.5 in.)
317.5 mm (12.5 in.)
63.5 mm (2.5 in.)
317.5 mm
(12.5 in.)
OR
mountholes
Figure 13: Mounting Hole Spacing
2.
Drill holes in the wall in the mounting feet locations you marked
in Step 1.
3.
Insert appropriate wall anchors in all four holes (if necessary) and
inset screws into the top two holes and hang the NAE on the
screws.
4.
Insert the screws into the last two mounting feet.
