Johnson Controls Kantech tyco ioSmart, Руководство по установке

Страница: 16 / 46

Changing the ioSmart card reader from standard to panel-
less mode
To change the ioSmart card reader from standard mode to panel-less mode, complete the following
steps:
1. If the reader is connected to a controller and authenticated, you must factory default it
before you can configure it as a panel-less reader. To factory default the reader, see Factory
default (SSF transmission format) .
2. To define the reader as panel-less, log on to Tyco Cloud: https://cloudvue.com/login .
a. On the Live page, on the Access tab, find the reader and click the Edit icon.
b. On the Settings page, in the General pane, from the Function Mode list, select
Panelless (Mobile Smart Key Door) .
3. From the EntraPass go Pass application, send three valid unlock requests in panel-less mode.
When an ioSmart card reader is in panel-less mode, it does not generate Wiegand code and it
cannot be connected over RS-485 to a controller.
Changing the ioSmart card reader from panel-less to
standard mode
To change the ioSmart card reader from panel-less mode to standard mode, factory default or
perform a hard reset on the reader.
Important: Forcing the reader to factory default deletes all custom settings from the reader,
and you may need to contact technical support to reset it. Therefore, it is highly recommended
not to factory default a panel-less reader but to perform a hard reset instead. To perform a
hard reset, see Hard reset (SSF transmission format) .
ioSmart Card Reader Installation Guide 16