Johnson Controls FX-PCX47, Руководство по установке

Страница: 3 / 22

Figure 3: FX-PCX47 Physical Features
Table 1: FX-PCX47 Physical Features Callouts and Descriptions
Physical Feature Description Callout
Binary Output (BO) Source Power Selection Jumper Pin Blocks, 3 – BO Jumper Pin Blocks. (See Table 3 ) 1
Device Address DIP Switch Block. (See Setting the Device Addresses ) 2
Mounting Clip (One of Three) 3
Configurable Output (CO) Terminal Blocks, 4 – Configurable Outputs. (See Table 3 ) 4
Analog Output (AO) Terminal Block, 2 – Analog Outputs. (See Table 3 ) 5
24 VAC, Class 2 Supply Power Terminal Block. (See Table 5 ) 6
Cover Lift Tab (One of Two). (See Removing the Controller Cover ) 7
Sensor/Actuator (SA) Bus or Field Controller (FC) Bus Terminal Block. (See Table 5 ) 8
Binary Input (BI) Terminal Block, 2 – Binary Inputs. (See Table 3 ) 9
Universal Input (UI) Terminal Blocks, 6 – Universal Inputs. (See Table 3 ) 10
End-of-Line (EOL) Switch. (See Setting the End-of-Line (EOL) Switch )
Note: The EOL Switch is located under the controller cover. You must remove the cover to change the EOL switch
position.
11
LED Status Indicators. (See Table 8 ) 12
Sensor Actuator (SA) Bus / Field Controller (FC) Bus Port (RJ-12 6-pin Modular Jack). (See SA/FC Bus Port ) 13
BO Terminal Block, 3 – Binary Outputs. (See Table 3 ) 14
3 FX-PCX47 Expansion Input/Output Module Installation Instructions