Johnson Controls CICS015B21S, Инструкция по эксплуатации

Страница: 14 / 72

FEATURES
1-6
TC-18004-rev.2
● Descriptions of Motion Sensor Control Condition
Condition
[Standard
Operation]
[MODE 1] [MODE 2] [MODE 3]
MENU
on Remote
Control Switch
“If Absent” - - -
Running
Operation
Standby Stop
*1)
Indoor Unit
Adjusting
Value of
Temperature
Setting
Adjusting
32
o
F
(0 o C)
Adjusting
34
o
F
(1 o C)
Adjusting
36
o
F
(2 o C)
Forced
Thermo-
OFF
[Mode 3]
Same
Condition
as Standby
Airflow
Volume
Setting
Airflow
Volume
Setting
Airflow
Volume-1
(Min: Low)
Setting
Airflow
Volume-1
(Min: Low)
Slo
Airflow
Direction
Set
Airflow
Direction
Horizontal Horizontal Horizontal
*1)
: The wired controller will make to stop the operation when all the indoor units with the motion sensors
switch to “MODE 3”. After the operation is stopped, the operation will not restart even if detecting the
human activity due to stopped by the wired controller. The indoor unit without the motion sensor and
the indoor unit with the motion sensor can be mixed. In this case, the indoor unit without the motion
sensor will also stop as shown in the figure below
*2)
.
Transmission Wire
for H-LINK ll
Transmission Wire
for Remote Control Switch
Indoor Unit A
(with Motion Sensor Kit)
Indoor Unit B
(with Motion Sensor Kit)
Indoor Unit C
(without Motion Sensor Kit)
Wired Controller
(CIW01)
On Motion Sensor Control
[Mode 3]
In the case of the motion sensor setting “If Absent: OFF” is
set by the wired controller.
On Motion Sensor Control
[Mode 3]
Operation Stop
Operation Stop
Operation Stop
No Motion Sensor
It is included all the connectable
indoor unit models.
*2)