Joerns Oxford Mermaid, Руководство пользователя

Страница: 20 / 32

20
English
Oxford
®
Mermaid & Ranger
14. Charging Instructions (Electric Variants)
The batteries are located in the power pack and are charged through a socket which also
serves as the power supply socket for the lift. The socket is labelled POWER/CHARGING
POINT. The battery pack on the Oxford Mermaid can be removed from the lift and charged
independently. An additional battery pack can be supplied, if required, so that one pack can be
on charge at all times.
1. Remove the power supply plug from the POWER/CHARGING POINT socket. The plug is
removed with a straight pull. DO NOT twist the plug in the socket. The battery pack can now
be removed from the lift for charging elsewhere. To remove the battery pack simply pull the
battery pack up by the handle on top of the pack and disengage the pack from the locating
pins on the mast. Reverse the process for reconnection.
2. Connect the battery charger plug to the POWER/CHARGING POINT socket. The plug is
indexed and can be fitted only one way. Make sure the red locking ring on the charging plug
is in the unlocked position (Moulded pointer on the locking ring pointing to the “Unlocked
position”). Connection is achieved with a straight push and then the locking ring can be
twisted to “Lock” position.
3. Plug the charger mains plug into a suitable mains outlet and switch the mains supply ON.
4. Charging is fully automatic. The status of the charging is indicated by two LED indicators
(see table below). Note: Even if the charger is left plugged in for extended periods it will not
allow the batteries to “overcharge”.
5. To return the lift to service, switch OFF the mains supply, twist the locking ring on the
charger plug to “Unlocked” and disengage from the POWER/CHARGING POINT with a
straight pull. DO NOT pull on the cable to disengage the plug. The power supply plug can
be reconnected with a straight push. DO NOT twist the plug in the socket. The lift is now
ready for use.
Charger Status LED Indicators
Bulk charger mode Yellow - static ON
Battery charged Green - static ON
Battery reversal detected Yellow - flashing
High temperature detected Green flashing simultaneously
Short circuit Green flashing alternately
Open circuit Green static simultaneously