Joerns Healthcare Hoyer HPL402, Инструкция пользователя и гарантия

Страница: 6 / 16

A s s e m b l y
IM-459000
6
ASSEMBLY
The following tools are required for assembly:
HPL402: 3/4" & 1/2" wrench, 3/16" hex wrench, 1/8"
hex wrench, and a thin layer of grease should
be applied to all bolts.
P-C-HLA-2: two 9/16" wrenches, 1/8" hex wrench, and
a thin layer of grease should be applied to
all bolts.
1. Carefully unpack Hoyer Lifter. Check for 6-point
cradle and adjusting lever handle.
2a.P-C-HLA-2– Insert mast in base sleeve
(Fig. 1). Be sure notch on end of mast fits over
bolt in bottom of mast sleeve. Mast must lock
into position in base sleeve, making it impossi-
ble to rotate. Check carefully to be certain mast
cannot rotate.
2b. HPL402– Insert mast in base and tighten bolt.
3. Make certain boom points in same direction as
base legs. Thread mast safety lock and stud into
threaded hole in mast sleeve. Tighten firmly,
locking mast into base (Fig. 2). Keep mast and
base locked at all times except when removing
mast from base for storage.
HPL402 only– all shoulder bolts must engage
through bracket on both sides. If bolt is not
fully engaged, misalignment and premature
failure may result. Worn parts could fail, result-
ing in injury to resident/caregiver.
4. a. P-C-HLA-2 only– Insert boom end into yoke
hinge at the top of mast. Fasten bolt and nut
(Fig. 3). Be certain hex of bolt head fits into
formed hex on side of hinge and that plastic
washer is under lock nut.
b. HPL402– Attach boom to top of mast with
hardware (Fig. 4).
Figure 1
Figure 2
Figure 3
Figure 4