Jobsite CT0964, Инструкция по эксплуатации

Страница: 11 / 16

the direction of the working-direction arrow .
● The machine can be both pushed or pulled in the cutting direction. Vertical
Slots can easily be cut by pulling the machine from top to bottom.
● After finishing the working procedure, swivel the cutting unit out of the slot with
the machine still running,until the cutting unit engages in the upper most position.
● Do not brake coasting diamond cutting discs by
applying sideward pressure.Diamond cutting discs
become very hot during operation; do not touch
them until they have cooled down.Remove the
remaining chips of the material with the break-out
tool B. Curved cuts are not possible,as the
diamond cutting discs could jam in the material.
When cutting through plate materials, ensure that
the materials are firmly backed on a surface or supported.
7. MAINTENANCE,TROUBLESHOOTING
Maintenance
1. Your power tool requires no additional lubrication or maintenance.
2. Never use water or chemical cleaners to clean your power tool.Wipe clean
with a dry cloth.
3. Always store your power tool in a dry place.
4. Keep the motor ventilation slots clean.
5. If you see some sparks flashing in the ventilation slots, this is normal and will
not damage your power tool.
6. If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
Troubleshooting
1. If your wall chaser will not operate, check the power at the mains plug.
2. If the diamond blade have been worn, replace the fresh blades and try again.
The blades must be kept in a dry place.
3. If a fault cannot be rectified return the tool to an authorized service center for
repair.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done with a soft brush.