Jobsite CT0964, Инструкция по эксплуатации

Страница: 10 / 16

6. OPERATION
1) Dismounting the Clamping Assembly (see figure).
Press the spindle lock button (3) to lock the output shaft.
Note: Actuate the spindle lock button(3) only when
the spindle is at a standstill. Otherwise, the machine
may become damaged.
Loosen the clamping nut (8) with the two-pin spanner
and unscrew the clamping nut (8). Remove the spacer
discs (6) and the mounting flange.
Start running
Press the switch lock button (10) and hold the trigger
switch (1), the chaser will start running.
The machine must always work in an up-grinding
motion. Otherwise, the danger exists of it being pushed
uncontrolled out of the cut. Guide the machine in the
direction of the working-direction arrow .
Stop running
To stop the running, simply release trigger switch (1) again, allow the switch
trigger to return to its original position.
Important information
● Do not strain the machine so heavily that it comes to a standstill.
● Clamp the workpiece if it does not remain stationary due to its own weight.
●The machine may only be used for dry cutting.
●Adjust the cutting depth,use Pre-selecting the Cutting Depth function.To
compensate inaccuracies that occur when breaking away the fin, the cutting
depth must be set approx.3mm deeper than the requested slot depth.
● Place the tool with the chaser rollers (5 )on the surface to be worked. The
cutting unit must be in the upper most position.
● Push the release button (3) upwards to release the cutting unit. Slowly lower
and plunge the cutting unit into the material.
● Guide the machine with both handles, applying mode rate feed, suited to the
material being worked.
● The machine must always work in an up-grinding motion. Otherwise, the
danger exists of it being pushed uncontrolled out of the cut. Guide the machine in