8
9
ASSEMBLY INSTRUCTIONS
OPERATION
Attaching the guard Assemble the guard
by sliding it over the head of the motor
housing and rotating it counter clockwise.
Using a proper screwdriver, secure the four screws
WARNING! During the use of tools supplied with batteries, the basic safety
personal injury, including the following precautions:
Ensure that the battery block is suitable for the tool.
Ensure that outside surface of the battery block is clean and dry before connecting it
to the charger.
Ensure that the batteries are charged using the correct charger recommended by
the manufacturer. Incorrect use can create a risk of electric shock, overheating or
the leaking of corrosive liquid from the battery.
If there is an electrolyte leak, avoid any contact with the skin. In the event of a leak,
wipe with a rag. If the liquid comes into contact with the skin, rinse abundantly with
water. In the event of a reaction or contact with the eyes or mucous membranes,
consult a doctor.
Ensure that the appliance is properly switched off before inserting the battery into
the appliance. Inserting a battery into a appliance while it is switched on can cause
accidents.
Use the appliance only with the type of battery indicated in the instructions. Using
Dispose of batteries: Ensure that the battery is properly disposed of:
1-Do not throw it away.
2-Do not to burn it.
3-Dispose of it in the designated collection containers (ask your retailer).
•
Always remove the battery whenever the following conditions apply:
- Whenever leaving the tool unattended.
- Before clearing a blockage.
- Before checking, cleaning or working on the unit.
- After striking a foreign object.
- Whenever the tool starts vibrating abnormally.
Additional Safety Instructions for Li-ion Line
Trimmer
Operating times
Please check noise abatement regulations prevailing in your country.
Charging A B C
Attention! Only use battery charger in dry places.
about 1-2 hours.
Use only the original charger.
1. Remove the battery from the device
A
.
2. Insert the battery into the charger
B
1
.
3. Connect the charger to the mains voltage
B
2
(LED
a
lights up red).
Notes on charger
B
• LED
b
lights up red: Battery is charging.
• LED
b
lights up green: Charging completed.
• LED
b
blinks red: Fault (e.g. battery is too hot).
Self-discharge of batteries! Remove the battery from
the charger once it is fully charged.
General instructions regarding the battery: In order
to maintain the long service life of the battery, always
Содержание YT7403
Страница 1: ......
