background image

Warnings and considerations

WARNING! 

Turn OFF electrical power before installing or servicing this 

product. Improper use or installation can cause SERIOUS INJURY, DEATH 

or LOSS/DAMAGE OF PROPERTY.

ATTENTION!

 ATTENTION! Coupez l’alimentation électrique avant 

d’installer ou de réparer ce produit. Une mauvaise installation ou utilisation 

peut entraîner des blessures graves, décès ou perte / dommages à la 

propriété.

WARNING!  

This device must be protected by a circuit breaker (20A max).

ATTENTION!

 Cet appareil doit être protégé par un disjoncteur (20A max.)

WARNING! 

Ground this device in accordance with the National Electric 

Code (NEC) requirements. DO NOT rely solely upon the yoke plate’s 

contact with a metal wallbox for adequate grounding. Use the device’s 

ground wire to make a secure connection to the safety ground of the 

electrical system.

ATTENTION! 

Cet 

appareil 

doit être en conformité avec le Code national 

de l’électricité (NEC). Ne comptez pas uniquement au contact de la 

plaque avant avec un boîtier mural métallique pour la mise à la terre 

adéquate. Utilisez cet 

appareil 

à la terre de l’appareil pour établir une 

connexion sécurisée au système électrique.

IMPORTANT! 

This device must be installed by a licensed electrician in 

accordance with all national and local electrical codes.

IMPORTANT! 

If you are unsure about any part of these instructions, 

consult a qualified electrician.

IMPORTANT!  

Use this device only with copper or copper-clad wire. Do 

not use aluminum wiring. This product has not been approved for use with 

aluminum wiring.

IMPORTANT!  

To reduce the risk of overheating and possible damage 

to other equipment, do not install to control a receptacle or a motor- 

operated appliance.

IMPORTANT! 

Using this product in a manner other than outlined in this 

document voids your warranty. Further, Control4 is NOT liable for any 

damage incurred with the misuse of this product. See “Troubleshooting.”

IMPORTANT! 

Do NOT use a power screwdriver to install this device. If you 

do, you may overtighten the screws and strip them. Also, overtightening 

the screws may interfere with proper button operation.

IMPORTANT! 

This is an electronic device with intricate components. 

Handle and install with care!

IMPORTANT! 

When used in conjunction with an Auxiliary Keypad 

(C4-KA-xx), the wire connecting the Auxiliary Keypad to the dimmer must 

not exceed 150 feet (45 m) at 120VAC, and 100 feet (30 m) at 277VAC.

Installation instructions

Ensure that the location and intended use meet the following criteria:

• 

Do not exceed the load capacity requirements of the dimmer. Refer to the 

load ratings in the specifications above for details.

• 

Install in accordance with all applicable national and local electrical codes.

• 

The range and performance of the wireless control system is highly 

dependent on the following: (1) distance between devices; (2) layout 

of the home; (3) walls separating devices; and (4) electrical equipment 

located near devices.

Turn off the local electrical power by either switching off the circuit breaker or 

removing the fuse from the fuse box. To ensure the wires do NOT have power 

running to them, use an inductive voltage detector.

Supported Model

• 

C4-TV120277  0-10V Dimmer

Introduction

The Control4® 0-10V Dimmer operates independently or as part of a Control4 

home automation system. It installs in a standard back box using typical wiring 

standards and communicates to the Control4 system using a wireless connection.

Box contents

• 0-10V 

Dimmer

• Wire 

nuts

• Warranty 

card

•  0-10V Dimmer Installation Guide

 (this document)

Specifications and supported load types

The specifications are described below.

Model number

C4-TV120277-xx

Power requirements

120-/-10%, 50/60Hz

This device requires a neutral AC connection. 
See “Sample Wiring Configurations” later in this 
guide.

Power consumption

120V: 485 mW

277V: 1.18 W

Load types and ratings

Supported load types

Four-wire 0-10V and 1-10V dimmable 
fluorescent ballasts and LEDs, sink or source.

Maximum load (switched hot)

120V: 15A

277V: 8A

Maximum load (0-10V 

Control)

100mA sink or source

Environmental

Operational temperature

32˚ F - 104˚ F  (0˚ C - 40˚ C)

All load ratings are based on an ambient  
temperature of 25˚ C

Humidity

5% to 95% non-condensing

Storage

-4˚F ~ 158˚F (-20˚C ~ 70˚C)

Miscellaneous

Control communications

ZigBee, IEEE 802.15.4, 2.4 GHz, 15-channel 
spread spectrum radio

Wallbox volume

5.75 cubic inches

Weight

0.12 lb. (0.05 kg)

Shipping weight

0.18 lb. (0.08 kg)

0-10V Dimmer  

Installation Guide

Содержание C4-TV120277

Страница 1: ...T This is an electronic device with intricate components Handle and install with care IMPORTANT When used in conjunction with an Auxiliary Keypad C4 KA xx the wire connecting the Auxiliary Keypad to the dimmer must not exceed 150 feet 45 m at 120VAC and 100 feet 30 m at 277VAC Installation instructions 1 Ensure that the location and intended use meet the following criteria Do not exceed the load c...

Страница 2: ... in the Faceplate Installation Guide or attach a standard Decora style faceplate 9 Turn ON power at the circuit breaker or replace the fuse from the fuse box NOTE If the light flickers adjust the dimmer s max min settings in Composer e g min 15 max 85 See ctrl4 co dimmersettings Operation and configuration On initial power up all status LEDs on the dimmer will illuminate green indicating that the de...

Страница 3: ...ary Keypad with neutral connection IMPORTANT When used in conjunction with an Auxiliary Keypad C4 KA xx the wire connecting the Auxiliary Keypad to the dimmer must not exceed 150 feet 45 m at 120VAC and 100 feet 30 m at 277VAC Auxiliary Linein Hot Black Black White White Red Purple Purple Neutralin Yellow Blue White AuxiliaryKeypad ...

Страница 4: ... or dba SnapAV in the United States and or other countries 4Store 4Sight Control4 My Home Snap AV Araknis Networks BakPak Binary Dragonfly Episode Luma Mockupancy Nearus NEEO Optiview OvrC Pakedge Sense Strong Strong Evolve Strong Versabox SunBriteDS SunBriteTV Triad Truvision Visualint WattBox Wirepath and Wirepath ONE are also regis tered trademarks or trademarks of Wirepath Home Systems LLC Othe...

Отзывы: