JNF IN.15.702, Руководство по установке

Страница: 30 / 44

INSTALLATION MANUAL / MI0216.1 www.jnf.pt
30/44
INSTALLATION INSTRUCTION
5.WIRING AND COMMISSIONING
5.7. Remote control (operating mode selector)
Automatic:
press button “ ” on the remote control to set the door to Automatic.
In this mode the door will open, stay open during an adjustable hold-open time (set
by the service technician) and close every time an activation device is triggered.
The activation devices can be a push button, a touch-less switch, radar or sensor.
“Push & Go”:
while the door is in automatic mode, you may manually push the
door leaf or simply pull from the door handle in the direction of opening, and the
leaf will open and close one cycle
Open:
press button “ ” on the remote control to set the door to Open. In this
mode, the door will slide from any position to open and stay in this position until
a new operating mode is selected. While the door is in Open mode, the leaf can be
moved, open or closed manually (very convenient for cleaning purposes), until a
new operating mode is selected, while the sensors will remain inactive to prevent
unwanted openings.
Closed:
press button “ ” on the remote control to set the door to Closed mode. In
this mode the leaf will slide from any position to fully close, while the sensors will
remain inactive to prevent unwanted openings, until a new operating mode is
selected. If the operator is equipped with an automatic lock (optional), the
door will
remain closed and blocked (*)
in that position until a new operating
mode is selected.
If the operator has no lock,
the door will slide to close position
and stay loose in manual mode (just like in Open mode), so it can be moved to any
position by hand.
Exit Only / Access control: press button “ ” on the remote control to set the
door to Exit Only mode. It is recommended to equip the door with an automatic
lock (optional) to use this function. In this mode, the activation devices (push
button, touchless switch, sensors and radars) on one side of the door will remain
active to allow the activation and opening of the door, while the devices on the
opposite side will remain inactive to prevent people activating the door from that
opposite side.
If the door is equipped with an automatic lock,
the door will lock
and stay blocked (*) every time the door slides to close position, until the door is
A
A
A A
SWITCH OFF
ACTIVATION IMPULSE
SWITCH ON
SWITCH OFF
ACTIVATION IMPULSE
T2
T1
C2
C1
A2
A1
activated from the activation devices which are enabled on one side of the door, or
a new operating mode is selected. In this mode, an
“Access control device”
such
as a card reader, keypad or finger print reader can be used to allow one full open
and closing cycle, after which the door will slide back to close position and remain
blocked by means of the automatic lock (if supplied).
(*)
Warning:
in the event of power failure, for safety reasons the lock is
programmed to release and unblock the door leaf so it can be moved manually to
open position.